One Four

(No Picture Available.)

This power module is only needed if you would like to use the FG580 Wired Alarm Console as a stand-alone Water Alarm System. It will power the FG580 Console locally.

If you are planning on integrating the FG580 with the rest of your water system by connecting it to the FG500 Water Sensor Interface Controller, power will come from the FG500 Controller, so you will not need this local power module.

Under Carpet Wired Water Sensor

The FG587 Supervised under-carpet Water Sensor is thinner than the FG586, so it is ideal for under a carpet. It does not have the case the FG586 does, and comes with 15' of four wire cable.

Dimensions: 2" x 3" x 0.18" (5.1 cm x 7.6 cm x 0.5 cm) has 15' cable

Supervised Wired Water Sensor

This sensor is a little shorter than a business card. It comes with 15' of four wire cable. Four of these sensors are included with the FG580.

Dimensions: 2" x 3" x 0.88" (5.1 cm x 7.6 cm x 2.2 cm) has 15' cable

This sensors works with the FG580 Wired Alarm Console.

FG580 Wired Eight-Zone Water Alarm and Detection Console. The FG580 provides an internal alarm buzzer with a silence switch, and eight LEDs on the console to identify the sensor causing the alarm.

The FG520 Wired Local Water Sensor Console is wired to the FG500 Water Sensor Interface Controller. It uses power from the FG500 to monitor the wired sensors attached to it, and comes with one FG571 Water Sensor. It can be used with up to five additional sensors for a maximum of six sensors.

Each water sensor has two contacts. When water forms a bridge between the two contacts, it triggers a water alert, which sends a signal to the FG500 to shut off the water in your home. As little as 0.16" of water can be sensed.

Small Profile Wired Water Sensor

The FG523 Small profile Water Sensor is 2.5" x 0.52" x 0.55", and comes with 6' of two wire cable. It is connected to the FG520 Wired Water Console.

Dimensions: 2.5" x 0.52" x 0.55" (63.5 mm x 13.2 mm x 14 mm)